Access
To define the execution parameters, open a SHELL session (MS/DOS session in Windows) and enter the following command:
"JAVA com.hardis.adelia.configuration.CfgParamExec"
where JAVA is the name of the virtual Java machine installed on the workstation.
Note: A dynamic setup technique is used for the configuration operations described in this section; this means you do not have to regenerate programs to have the new setup taken into account. The system loads the parameters specified in the interface configurator when it enters the application.
The configuration parameters are set out on three pages:
To change either of these pages, just click the relevant tab.
The buttons described below are valid for the whole dialog box, whichever page is active.
Buttons
OK
This button validates the modifications made and closes the dialog box.
Cancel
This button closes the dialog box without validating the modifications made.
Keyboard shortcut: Esc.
Apply
This button validates the modifications made and applies the new parameters immediately.